.

Using masking tape.

Tape each side and line up to approx location.

Find a spot to measure that will be equal on both sides.

Center the sticker so it is equal on both sides.

Now measure from a spot above sticker.

On both sides of sticker.

 Peal tape and reposition to align straight.

Place 2 strips of masking tape down the middle of sticker. So it extends couple inches past backing.

This will be the main holding tape. So make sure it sticks top and bottom.

Peel the backing off one side .

Using scissors cut off the backing up to the center tape.

DO NOT LET GO OF STICKER. HOLD BACK FROM STICKING.

Using a squeegee or other applicator.

 Hold sticker back at about 45 deg.

Allow the sticker to go flat when pushing squeegee from tapped center to outside.

Keep squeegee flat at all times. Smooth out sticker.

Remove small tape and pull back other side.

You can remove the center tape at this time..

Peel off backing.

Hold sticker at all times so it does not touch.

Place squeegee in center of sticker.

Hold flat and push out.

Hold other end of sticker in hand about 45 deg.

Allowing sticker to lay flat as squeegee pushes it.

Smooth out with soft scratch free cloth.

HOME